c1283-98中文版-安装粘土烟道内衬的标准实施规程.docVIP

C 1283 PAGE 862 Designation: C 1283-98编号: C 1283-98 PAGE 857 Standard Practice for Installing Clay Flue Lining1安装粘土烟道内衬的标准实施规程 This practice is under the jurisdiction of ASTM Committee C-4 on Vitrified Clay Pipe and is the direct responsibility of Subcommittee C04.20 on Methods of Test and Specifications. Current edition approved March 10, 1998. Published March 1999. Originally published as C 1283-94. Last previous edition C 1283-97.该实施规范归ASTM负责陶土管的C-4委员会管辖，并由负责测试方法和规格的C04.20小组委员会直接负责。现行版本于1998年3月10日批准，并于1999年3月出版。最初版本编号为C1283-94，上一版本编号为C 1283-97。 This standard is issued under the fixed designation C 1283; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C1283刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 This practice covers the minimum requirements for installing clay flue lining as a lining for residential masonry chimneys not exceeding 40 ft (12.2 m) in height.本规程覆盖安装粘土烟道内衬的最低要求，此处指高度不超过40英尺（12.2米 The values stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are for informational purposes only.用英寸磅单位表示的数值为标准值。括号内所给出的值仅供参考。 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.本标准并非旨在解决所有与标准使用相关的安全问题（如有）。本标准使用者有责任确立适用的安全和健康规范并在使用前评估其是否符合有关条例。 2. Referenced Documents参考文件 2.1 ASTM Standards:ASTM标准: C 24 耐火土和高氧化铝耐火材料的耐火度试验方法 Annual Book of ASTM Standards, Annual Book of ASTM Standards, Vol 15.01.ASTM标准年鉴第15.01卷。 C 27 耐火土及高矾土耐火砖的标准分类2 Classification of Fireclay and High-Alumin