c1312-97中文版-实验室中抗化学性硫高聚水泥试验样品制作和调合的标准规范.docVIP

C 1312 PAGE 878 Designation: C 1312 - 97编号: C 1312 - 97 PAGE 877 Standard Practice forMaking and Conditioning Chemical-Resistant Sulfur Polymer Cement Concrete Test Specimens in the Laboratory1实验室中抗化学性硫高聚水泥试验样品制作和调合的标准规范 This practice is under the jurisdiction of ASTM Committee C-3 on Chemical-Resistant Nonmetallic Materials and is the direct responsibility of Subcommittee C03.02 on Mortar and Monolithics. This practice is under the jurisdiction of ASTM Committee C-3 on Chemical-Resistant Nonmetallic Materials and is the direct responsibility of Subcommittee C03.02 on Mortar and Monolithics.该实施规范归ASTM负责抗化学性非金属材料的C-3委员会管辖，并由负责测试方法和规格的C03.02小组委员会直接负责。Current edition approved October 10, 1997. Published February 1998. Originally published as C 1312-96. Last previous edition C 1312 - 96.现行版本于1997年10月10日批准，并于1998年2月出版。最初版本编号为C1312-96，上一版本编号为C 1312-96。 This standard is issued under the fixed designation C 1312; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C1312刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This practice covers procedures for making and conditioning test specimens of chemical-resistant sulfur polymer cement concrete (SC) in the laboratory. The specimens are cast under accurate control of materials and test conditions using aggregate and sulfur polymer cement (SPC) to make SC that can be consolidated by rodding, as described in this practice.本规程涵盖在实验室中制作和调合抗化学药品的硫高聚水泥混凝土的试验样本的程序。如本标准规程内容所描述，通过准确地控制材料和试验条件，使用骨料、硫高聚水泥能够制作硫高聚水泥混凝土（以下简称SC）。可以对SC进行搅拌加固。 1.2 Sulfur polymer cement may be furnished as a single or multiple component system.硫高聚混凝土可作为单成份系或者多成份系提供。 1.3 The values stated in inch-pound units are to be regarded as the standard. T