c1314-98a中文版-用于测定与砌块的特定抗压强度一致性的砌块棱柱的建造和试验的标准试验方法.docVIP

C 1314 PAGE 881 Designation: C 1314-98a编号：C1314-98a *A Summary of Changes section appears at the end of this standard.*修订汇总部分见本标准末。 PAGE 880 Standard Test Method forConstructing and Testing Masonry Prisms Used to Determine Compliance with Specified Compressive Strength of Masonry This test method is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.04 on Research. 本规范归ASTM负责成品砌块的C-15委员会管辖，并由C15.04研究分委会直接负责。Current edition approved Nov. 10, 1998. Published March 1999. Originally published as C 1314-95. Last previous edition C 1314-98. This test method is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.04 on Research. 本规范归ASTM负责成品砌块的C-15委员会管辖，并由C15.04研究分委会直接负责。Current edition approved Nov. 10, 1998. Published March 1999. Originally published as C 1314-95. Last previous edition C 1314-98. 现行版本于1998年11月10日批准，并于1999年3月出版。最初版本编号为C1314-95，上一版本编号为C1314-98。 This standard is issued under the fixed designation C 1314; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C1314-98a刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope * 适用范围* 1.1 This test method covers procedures for masonry prism construction and testing, and procedures for determining the compressive strength of masonry, fmt, used to determine compliance with the specified compressive strength of masonry, f’m本试验方法涉及了用于测定与砌砖的特定抗压强度（fmt）一致性的砌砖棱柱的建造和试验程序，以及测定砌砖抗压强度（f’m）的程序。 Note 1—Although this test method is similar in many respects to Test Methods C 1388, Test Methods C 1388 requires collection of additional detailed information associated with resea