c1319-98中文版-混凝土格子铺设装置的标准规范.docVIP

C 1319 PAGE 888 Designation: C 1319-98编号：C 1319-98 PAGE 887 Standard Specification for Concrete Grid Paving Units This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.03 on Concrete Masonry Units and Related Units.本规范受ASTM委员会C-15制造砌块委员会管辖，并且由C15.03水泥砌块及相关单位 This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.03 on Concrete Masonry Units and Related Units.本规范受ASTM委员会C-15制造砌块委员会管辖，并且由C15.03水泥砌块及相关单位分委会直接负责。Current edition approved May 10, 1998. Published November 1998. Originally published as C 1319-95. Last previous edition C 1319-97.现行版本于1998年5月10日批准，并于1998年11月出版。最初版本编号为C1319-95，上一版本编号为C1319-97。 This standard is issued under the fixed designation C 1319; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 1319刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope 适用范围 1.1 This specification covers the requirements for concrete grid paving units for vehicular trafficways, parking areas, soil stabilization, and revetments. Maximum dimensions are 24 long by 24 in. wide (610 by 610 mm), with a minimum nominal thickness of 3/s in. (80 mm).本规范包含车辆通道、停车场、土壤稳定和护岸的混凝土格子铺设装置的要求。最大尺寸为长24英寸×宽24英寸（610毫米×610毫米），最小公称厚度为31/8英寸（80毫米）。 Note 1—When particular features are desired, such as weight classification, higher compressive strength, surface texture, finish, color, or other special features, such properties should be specified separately by the purchaser. However, local sellers should be consulted as to availability of units having the desired features.注1——当需要特殊特征时，比如重量分类、较高抗压强度、表面