c1298-95中文版-工业烟囱砖衬设计和施工的标准指南.docVIP

C 1298 PAGE 892 Designation: C 1298 – 95编号：C 1298 – 95 PAGE 864 Standard Guide forDesign and Construction of Brick Liners for Industrial Chimneys1工业烟囱砖衬设计和施工的标准指南 This guide is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee CI5.09 on Chemical-Resistant Units.本指南归ASTM负责砌块制造的C-15委员会管辖，并由C15.09石棉水泥板制品及附件分委会直接负责。Current edition approved June 15, 1995. Published August 1995.现行版本于1995年6月15日批准，并于1995 This standard is issued under the fixed designation C 1298; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (€) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 1298刊发；紧随编号后的数字表示最初采用的年份，或是修订版的最后修订年份。圆括号中的数字表示最新重新核准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell.本指南涵盖工业烟囱用砖衬的设计、施工及适用性。结构设计准则适用于仅在其基础部位由地基、或混凝土基座、或由外层混凝土薄壳所支撑的垂直砌块悬臂结构。由在烟囱外壳上所浇铸的支撑在一系列托架上的单吊杆可组合砖衬不应直接考虑。 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.由英制单位所表示的数值视为标准数值，圆括号中所给出的数值仅供参考。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prio