c1374-97中文版-测定气动施加的宽松填充建筑物绝热材料安装厚度的标准试验方法.docVIP

C 1374 PAGE 799 Designation: C 1374-97编号: C 1374-97 PAGE 790 Standard Test Method forDetermination of Installed Thickness of PneumaticallyApplied Loose-Fill Building Insulation1测定气动施加的宽松填充建筑物绝热材料安装厚度的标准试验方法 This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.本试验方法由ASTM绝热材料委员会C-16委员会6管辖，并由C16.32机械性能分委会直接负责。Current edition approved July 10, 1997. Published August 1998.现行版本于1997年7月10日批准，并于1998年8月出版。 This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.本试验方法由ASTM绝热材料委员会C-16委员会6管辖，并由C16.32机械性能分委会直接负责。Current edition approved July 10, 1997. Published August 1998.现行版本于1997年7月10日批准，并于1998年8月出版。 This standard is issued under the fixed designation C 1374; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C1374刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 This test method covers determination of the installed thickness of pneumatically applied loose-fill building insulations prior to settling by simulating an open attic with horizontal blown applications.本试验方法适用于在安放之前通过水平吹风以模拟敞开阁楼来测定气动施加的宽松填充建筑物绝热材料安装厚度。 This test method is a laboratory procedure for use by manufacturers of loose-fill insulation for product design, label development, and quality control testing. The apparatus used produces installed thickness results at a given mass/unit area.本试验方法为实验室程序，可供宽松填充绝热材料制造商在产品设计、标签编制和质量控制测试时使用。所用仪器应在指定的整体/单位面积上生成安装厚度结果。 This test method is not the same as the design density procedures described in Test Methods C 520 or Specificatio