c980-88中文版-工业烟囱砌壁砖的标准规范.docVIP

C 980 PAGE 655 Designation: C 980 - 88 (Reapproved 1995)ε1 编号：C 980-88（1995年重新审批）ε1 PAGE 654 Standard Specification for Industrial Chimney Lining Brick This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C 15.09 in Chemical-Resistant Units. This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C 15.09 in Chemical-Resistant Units.本规范由ASTM委员会C-15人造砌筑块委员会管辖，并由C15.09抗耐化学性部件分委会直接负责。 Current edition approved Feb. 1, 1988. Published April 1988. Originally published as C 980 - 82. Last previous edition C 980 - 82.现行版本于1988年2月1日批准，并于1988年4 This standard is issued under the fixed designation C 980; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 980刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 ε1 Note—Keywords were added editorially in June 1995.ε1注——1995年6月编辑添加了关键词。 1. Scope 适用范围 1.1 This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars.本规范涉及由粘土、页岩或其混合物所制成的实心窖烧砖，此类砖适用于与工业烟囱中的烟气含有的化学品相接触的砌筑结构。这些砖块通常与耐化学性灰浆一起使用。 1.2 The physical and chemical properties of chimney lining brick differ from supplier to supplier mainly because their composition is determined by the source of raw materials. Chimney lining brick, regardless of these differences, are considered to be of three types noted as follows:由于烟囱砌壁砖的成分由原料来源决定，因此每个供应商所提供的砌壁砖的物理和化学特性各不相同。若不计这些差异，烟囱砌壁砖主要可分为以下三种类型： 1.2.1