使用PE29102驱动器作为差分电压转换器.pdfVIP

Using the PE29102 Driver as a Differential Voltage Translator Application Note 70 Summary This application notes describes how to configure the PE29102 UltraCMOS® High-speed FET Driver as an adjustable level, high slew rate, differential voltage translator and shows an example of this implementation. Introduction The Peregrine Semiconductor PE29102 is a high-speed driver that can be configured to provide a high slew rate differential signal with adjustable output levels. In this configuration, the PE29102 can be used to provide the control signal requirement for the Peregrine PE42525 60 GHz RF switch. The PE29102 provides the required 3.0V control signal, with a high slew rate that matches the high switching speed of the PE42525 switch. Figure 1 and Figure 2 show the functional diagram for each device. The PE29102 differential outputs are the HSG and LSG signals used to drive the PE42525 V1 and V2 control signals. Table 1 shows the PE42525 control truth table. Figure 1 • PE29102 Functional Diagram ©2017, Peregrine Semiconductor Corporation. All rights reserved. • Headquarters: 9380 Carroll Park Drive, San Diego, CA, 92121 Application Note DOC-85735-1 – (10/2017) Application Note 70 Using the PE29102 Driver Figure 2 • PE42525 Functional Diagram RFC RF1 RF2 ESD