如何搭建_Application_Adding_PLIB_ 驱动和中间件 _to_MPLAB_Harmony_v3Project_DS90003253A.pdfVIP

TB3253 How to Build an Application by Adding a New PLIB, Driver, or Middleware to an Existing MPLAB Harmony v3 Project Introduction ® This document describes how to add new peripheral libraries (PLIBs), driver, or middleware to a generated MPLAB Harmony v3 project. An existing MPLAB Harmony v3 project can be found from one of the following sources: 1. Created from scratch. 2. From the apps folder from one of the GitHub MPLAB Harmony v3 repositories. 3. An example of application demonstration code was downloaded from one of the 32-bit MCU development kits or a product page. For example, from the Documents and Software tab in Curiosity PIC32MZ EF 2.0 Development Board product page. 4. An example project received from Microchip as a reference. This document is a guide for launching an existing application in MPLAB X IDE and extending it. New PLIBs, drivers, system services, or middleware can be added as required by the end user application. © 2020 Microchip Technology Inc. Technical Brief D TB3253 Description 1. Description Downloading and Installing the MPLAB Harmony v3 Software Development Framework To download and use the MPLAB Harmony v3 software development framework, refer to the document How to setup MPLAB Harmony v3 Software Development Framework. Note:  As a recommendation, the user must download or keep the latest MPLAB Harmony v3 repositories using the