AS 2197-1978 国外国际规范下载.pdf

AS 2197—1978 Australian Standard MICROGRAPHIC ASSESSMENT OF THE NON-METALLIC INCLUSION CONTENT IN WROUGHT STEEL The following scientific, industrial and governmental organizations and departments were officially represented on the committee entrusted with the preparation of this standard: Bureau of Steel Manufacturers of Australia Commonwealth Aircraft Corporation Confederation of Australian Industry Department of Defence Federated Chamber of Automotive Industries Institute of Steel Service Centres of Australia Metal Trades Industry Association of Australia Railways of Australia Committee Society of Automotive Engineers— Australia Telecom Australia University of New South Wales (School of Metallurgy) This standard, prepared by Committee MT/18, Metallography, was approved by the Metals Standards Board on behalf of the Council of the Standards Association of Australia on 31 May 1978, and was published on 1 November 1978. Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto. Full details of all Australian Standards and related publications will be found in the Standards Australia Catalogue of Publications; this information is supplemented each month by the magazine ‘The Australian Standard’, which subscribing members receive, and which gives details of new publications, new editions and amendments, and of withdrawn Stand