ibm3584磁带库微码升级指导使用指南v21.docVIP

IBM 3584 磁带库微码升级指导手册 v2.0 安图特(北京)科技有限公司 范翔 注：1.本文档摘录南 84-L52 微码升级的相关信息 2.建议通过 IB y Specialist 进行微码升级 3.如果 3584 磁 于 6050，微码升级可以在生产环境中进行，即无需停止相 关作业。 升级步骤 1. 下载微 最新的微 如下地址获得： ftp://f /storage/358 http: /servers/storage/sup 2. 升级前停止有关 3584 的使用 3. 操作 3584 的液晶触摸屏，按 MENU — Settings rk — Ethernet — ENTER 屏幕 为 入 3584 背部的网口，并且配置笔记本 IP 与其在同一网段 打开浏览器，输入 ，进入如下界面 6. 确认 3584 的 VPD 1 7. 选择 Firmware Update，根 操作 2 3 8. 微码升级正式开始。操作触摸屏会显 度，大约 30 分钟后，升级 毕。操作触摸屏显示新的微码版本 Version 9. 对 3584 磁带库进行健康检查，确认没有问题。 4 附录 IBM 3584/TS3500 UltraScalable Tape Library Firmware Readme Firmware level 7379: Library code version 9 adds the following new functions: - Support for new cal /offset mode (enabled using CE Tool v4.6 or higher) Significant fixes s code version 7369: - Fixed problem w edundant parts, such as gripper, would not be correctly reported through - Fixed problem h Car dge Assignment Policy set to all other volser that would intermit idge exp with ASC/ASCQ 3B81 indicating a wrong logical library gets a - Fixed prob HA library coul Not Ready to the host after a new frame got added usi ced disruptive fram thod. - Fixed p ere a library would als ny media type from being inserted becaus nsert limited on one media - Fixe m where a library with encrypti fail an encryption job when the cart memory volser did not match the bar and neither volser was in a ba e encryption policy. - xed problem where incorrect error codes would b ms with redundant components such as gripper. - Fi t when SNMP is used. configured or with ALMS with VIO disabled; where an I/O but when a cartridge was sent to the I/O station, it unlocked. lem for libraries with ALMS enabled where only unassigned cartridges get ported even so both unassigned and shared cartridges were selected for export at the same time. - Fixed problem for libraries static configured or with ALMS with VIO disabled, that has two I/O stations in the L-frame; where only one I/O station gets locked during cartridge export, even though both I/O stations are