edem后处理软件ensight教程.docVIP

Using EDEM with EnSight Using EDEM with EnSight Copyrights Copyright ? 2002-2008 DEM Solutions. All rights reserved. Information in this document is subject to change without notice. The software described in this document is furnished under a license agreement or nondisclosure agreement. The software may be used or copied only in accordance with the terms of those agreements. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or any means electronic or mechanical, including photocopying and recording for any purpose other than the purchaser’s personal use without the written permission. DEM Solutions 20 York Place Edinburgh EH1 3EP UK EDEM incorporates CADfix translation technology. CADfix is owned, supplied by and Copyright ? TranscenData Europe Limited, 2007. All Rights Reserved. Trademarks EDEM and Particle Factory are trademarks or registered trademarks of DEM Solutions in the United Kingdom and/or other countries. Fluent is a registered trademark of Fluent Inc. in the United States and/or other countries. EnSight is a registered trademark of Computational Engineering International, Inc (“CEI”). Other brands and their products are trademarks or registered trademarks of their respective holders and should be noted as such. Licensing EDEM licensing uses Sentinel RMS. See the SafeNet website () for details. 2 Using EDEM with EnSight Contents Introduction .....................................................................................................................4 Exporting Data from FLUENT and EDEM........................................................................4 Exporting Data for an Image........................................................................................4 Exporting Data for an Animation ..................................................................................4 Creating a 2-Phase Image or Animation....................................................................