-Unlicensed-塑料热性能测试英语.pptVIP

tt Plastic thermal performance test 主讲人：杨崇岭 电脑热变形维卡软化点测定仪 负荷热变形温度测定仪 数显智能温控线膨胀系数测定仪 熔融指示仪 塑料低温冲击脆化温度测定仪 Words and Expressions be subjected to 受 corresponding 相应的 flexural 弯曲 striking [?stra?k??] adj. 引人注目的;显著的 coefficient 系数 quartz 石英 differential [?d?f??r?n??l] adj. 差别的 calorimeter 量热仪 thermocouple 热电偶 flux 通量 curve 曲线 clamped 夹 provision [pr??v???n] n. 规定，条项 brittleness 脆性 1 Thermal deformation test A standard test specimen is subjected to three-point bending under a constant load in the flatwise (preferred) or the edgewise position to produce one of the flexural stresses given in the relevant part of this International Standard . The temperature is raised at a uniform rate , and the temperature at which the standard deflection , corresponding to the specified increase in flexural strain ,occurs is measured . 1 Thermal deformation test Unless otherwise specified in the relevant part of this intemational Standard , express the flexural temperature of the material under test results to the nearest degree Celsius. 2 Low temperature brittleness temperature The striking edge shall move relative to the test piece(s) along a path normal to the upper surface of the test piece(s) at a linear testing speed of 0,2 m/s at impact. The speed shall be maintained within this range for at least 6 mm of travel following the impact. 2 Low temperature brittleness temperature In order to obtain a speed within the specified limits during and after impact, care shall be taken to ensure that the striking energy is sufficient. It has been found that a striking energy of at least 3,0 J per test piece is necessary. It might, therefore, be necessary to limit the number of test pieces impacted at one time. 3 Plastic linear expansion coefficient test The coefficient of linear expansion is the percentage change in the length of the