AS 5200.037.2-2008 国外国际规范.pdf

AS 5200.037.2—2008 A S 5 2 0 0 . 0 3 7 . 2 — 2 0 0 8 Australian Standard® Plumbing and drainage products Part 037.2: Flow controllers for use with heated or cold water systems This Australian Standard® was prepared by Committee WS-001, Water Fittings. It was approved on behalf of the Council of Standards Australia on 10 April 2008. This Standard was published on 30 June 2008. The following are represented on Committee WS-001: • AUSTAP • Australian Industry Group • Australian Stainless Steel Development Association • Building Officials Institute of New Zealand • Certification Interests (Australia) • Copper Development Centre—Australia • Master Plumbers Association of NSW • Master Plumbers, Gasfitters and Drainlayers New Zealand • Plastics Industry Pipe Association of Australia • Plastics New Zealand • Plumbing Distributors Association of New Zealand • Queensland Brassware Industry Advisory Panel • South Australian Water Corporation • Testing Interests (Australia) • Water Corporation Western Australia This Standard was issued in draft form for comment as DR 07137. Standards Australia wishes to acknowledge the participation of the expert individuals that contributed to the development of this Standard through their representation on the Committee and through the public comment period. Keeping Standards up-to-date Australian Standards® are living documents that reflect progress in science, technology and systems. To maintain their currency, all Standards are periodi