开利：数据中心行业市场及解决方案V2.0.pptVIP

* 三转子大大降低了轴承上的负载。比如， 最短使用寿命为10年的23XRV的轴承为500，000小时，约为连续运行57年。 三转子更高效、更可靠。只要将一个VFD放在一般的双螺杆上是不能产生23XRV的性能，也没有23XRV可靠。 该处的滑阀必须与旋转转子有一段间隔距离（否则将摩擦，发生故障）。而这将产生一个泄漏通道，降低效率。使用变速设备取代滑阀，就可以降低复杂性和损耗。 再者，三转子设计还可以允许最大限度的降速，但不会因此限速或只能用双螺杆转子。 Heeren, a 50,000 sqft office and retail office in Orchard Road. This retrofit project was completed in June 2009, combining 2 separate plant rooms in one using 4 units of 550RT 23XRV in series counter flow. * Here we show how the water flows through chillers in series counterflow. (series evaps and series condensers) Cooler water returns from CH-2 then CH-1. And condenser water flows from CT back to CH-1 then CH-2. Upstream and downstream chillers will share the CHW and CW dT. * * Using that pressure enthalpy chart to demonstrate why this Series Counterflow works. WE ARE REDUCING CHILLER LIFT AT FULL LOAD / DESIGN CONDITIONS. (STILL 100% LOAD, 29.4C ECWT!) The SCT is able to reduce from 36.1C to 33.3C, thus moving the heat rejection line down for points 2 3. (Don’t do this with centrifs). Since they share the same water, whatever one centrif does to pull out of surge, will effect the conditions of the other centrifugal – likely throwing it right into surge. * We save lift on the upstream chiller because it is only making 11.1C water. Raising the SST from 5.5C to 10C, moving line A1 up to the blue dotted line. This helps to reduce the lift make upstream chiller more efficient. With 23XRV, SCF is an ideal application where it can optimise the part load performance. * This is a typical parallel configuration with primary and secondary pumping systems. With SCF, a primary-only variable flow system can eliminate one set of pumps, utilizes all 2-way valves at the coils, and varies the flow through chillers as well as all the coils throughout the building. The whole idea is to save system-pumping costs by varying the flow using VFDs, while eliminating the first and operating costs of separate chiller pumps. Hence, SCF is a cart