美国船级社标准ABS Corrigenda Generic Rules for Materials and Welding (Part 2) .pdf

RULES FOR MATERIALS AND WELDING 2008 CORRIGENDA/EDITORIALS – 31 March 2008 CORRIGENDA/EDITORIALS – 1 July 2008 Page No. Paragraph Comments Part 2 Rules for Materials and Welding Chapter 1 Materials for Hull Construction Section 2 Ordinary-strength Hull Structural Steel 31 2-1-2/Table 4 In last column for all grades, “28” to read “2.8”. Part 2 Rules for Materials and Welding Chapter 3 Materials for Machinery, Boilers, Pressure Vessels and Piping Section 7 Steel Machinery Forgings 168 2-3-7/Table 1 Cr Mo V + + Ni Cu+ Mn In Note 2, equation to read “Ceq = C + + + (%)”. 6 5 15 Part 2 Rules for Materials and Welding Chapter 4 Welding and Fabrication Section 2 Boilers, Unfired Pressure Vessels, Piping and Engineering Structures 297 2-4-2/Table 1 In columns for MODU Rules , references “4-2-1/7” (two places) and “4-2-4/15.7” to read “6-1-1/13” and “6-1-1/21”, respectively. Part 2 Rules for Materials and Welding Chapter 4 Welding and Fabrication Section 3 Weld Tests 320 2-4-3/Figure 9 In lower figure, joint angle to read “60°” as follows: