燃气电控系统PPT课件.ppt

34 NOTES: Note that the orifice is connected to the intake air tap. 34 NOTES: Note that the orifice is connected to the intake air tap. 34 NOTES: Note that the orifice is connected to the intake air tap. 50 24 NOTES: This type of UEGO is referred to as a “pumping” sensor since it uses an electrochemical cell as a tiny oxygen pump. The sense cell outputs approximately 0.45 volts relative to the sense/pump - wire when the sensor is operating. The pump cell current is less than 10mA. The heater may pull up to 4A when the sensor is cold. The calibration resistor value will be anywhere from 100 ohms to 4000 ohms. 17 18 NOTES: The notation “f(...)” means “function of ...” or “dependent on ...” VE is volumetric efficiency. PW is fuel injector pulse width. 26 27 39 Definitions: FPP - Foot Pedal Position TPS - Throttle Position Sensor TPSc - Throttle Position Sensor Command 9 NOTES: Inductive ignition systems provide longer duration sparks than capacitive discharge systems. NG has an equivalent octane number of about 130 or 140. However, an NG engine will still knock and detonate under high boost with a rich enough mixture. High humidity causes reduced power and increased probability of misfire. 13 Definitions: FPP - Foot Pedal Position TPS - Throttle (blade) Position Sensor Tach - Tachometer Drive FuelGauge - Fuel Gauge Drive MIL - Malfunction Indicator Light Idle - Fast (Increased) Idle Input Oil - Oil Pressure Switch Switch - Run/Start + power from ignition switch 机油压力监测 OH1.2 ECM 可对机油压力进行监测 机油压力低时，增压被限值 在转速升高时如果机油压力一直较低，系统故障灯闪烁 温度压力传感器 温度压力传感器 集成压力温度的传感器 用途 燃料喷射计算 增压控制 压力传感器 测量进气管绝对压力 测量范围从真空到增压压力 温度传感器 测量进气歧管压力 不可同PTP互换 节气门前压力传感器 集成温度压力传感器 仅用来测量压力 和 TMAP不同的标定 不能和 TMAP互换! 点火控制 点火控制 点火系统 点火控制模块 点火线束 线圈、火花塞 点火控制模块 老版本（K版之前） 新版本点火模块（K版或更新的版本） 点火控制模块 ICM = 点火控制模块 ICM 只是一个驱动盒，在点火线圈开始充电时它从ECM接收到信号 当来自于ECM的触发信号上升时 ICM打开点火驱动并寻找相应的点火线圈 初级电流上升到6.5A 在触发信号下降前初级电流保持在6.5A 当触发信号下降时，ICM驱动电流降低到初级电流 产生火花 来自ECM的复位脉冲触发ICM再次在第一缸点火 点火控制 OH-I ECM OH-I ICM 触发信号 标记信号 V+ V+