CCNA标准实验03静态路由配置.docx

CCNA标准实验03――静态路由的配置 配置路由器ccnal Routere n Router#c onf t En ter con figurati on comma nds, one per line. End with CNTL/Z. Router(config)#hostname ccna1 // 配置路由器主机名 ccna1(config)#enable password cisco1 II 配置 password 密码 ccna1(config)#enable secret cisco2 II 配置 secret ccn a1(c on fig)#li ne vty 0 4 ccna1(config-line)#password cisco II 配置 vty ccn a1(c on fig-l in e)#log in ccn a1(c on fig-l in e)#li ne con sole 0 II 配置 console 口 密码 ccn a1(c on fig-l in e)#password cisco3 ccn a1(c on fig-l in e)#log in ccn a1(c on fig-l in e)#exit ccn a1(c on fig)#service password=e n ccn a1(c on fig)#service password-e n ccna1(config)#service password-encryption II 加密密码 ccn a1(co nfig)#i nt faO/O ccna1(config-if)#ip address 192.168.1.1 255.255.255.0 II 配置接口 IP地址 ccn a1(c on fig-if)# no shutdow n %LINK-5-CHANGED: In terface FastEthernet0/0, changed state to up ccna1(config-if)#description ? LINE Up to 240 characters describ ing this in terface ccna1(config-if)#description this port is conneting to ccna2 II 配置接口描述信息 ccn a1(c on fig-if)#exit ccna1(config)#do show clock II 强制显示时钟 *0:5:28.301 UTC Mon Mar 1 1993 ccn a1(c on fig)#exit ccna1# %SYS-5-CONFIG_l: Con figured from con sole by con sole ccn a1#clock set ? hh:mm:ss Curre nt Time ccna1#clock set 17:54:50 1-31 Day of the month MONTH Month of the year ccna1#clock set 17:54:50 July 4 2013 // 配置软时钟 ccna1#conf t Enter configuration commands, one per line. End with CNTL/Z. ccna1(config)#clock ? timezone Configure time zone ccna1(config)#clock timezone ? WORD name of time zone ccna1(config)#clock timezone BJ ? -23 - 23 Hours offset from UTC ccna1(config)#clock timezone BJ +8 // 配置时区为当前北京时间 配置路由器 ccna2 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname ccna2 ccna2(config)#enable password cisco1 ccna2(config)#enable secret cisco2 ccna2(config)#line vty 0 4 ccna2(config-line)#password cisco ccna2(config-line)#login ccna2(config-line)#line console 0 ccna2(config-line)#password cisco3 ccna2(c