ansys内部例题详解.docxVIP

郑重申明：本人能力有限，文中不可避免会有错误，欢迎朋 友们批评指正，希望大家相互提高，呵呵，谢谢啦！ 12.8. Sample Rigid Body Dynamic Analysis 刚体动力学分析实例 This sample an alysis dem on strates how to model a flexible comp onent in ANSYSand export the flexible body information to a file for use in ADAMS. The example also provides brief instructions on how to perform the rigid body dynamic analysis in ADAMS, anddetails on how to transfer the loads from ADAMS to ANSYS in order to perform a stress an alysis. 该实例演示了如果在ANSY中制作柔性部件及输出可在ADAM中使用的柔性体信 息文件。同样该例子也提供了有关于在 ADAM中进行动力学分析的简单介绍，和 如何将载荷信息从ADAM转换到ANSY卿进行应力分析的详细介绍。 12.8.1. Problem Description 问题描述 In the linkage assembly shown below, Link3 is a flexible component. Link3 is modeled as a rectangular rod in ANSYSUsing SOLID45elements. The joints in ADAMS will be attached to in terface poi nts (no des) at the middle of the holes at either end of Lin k3. These middle points are conn ected to the cyli ndrical joi nt surfaces by a spider web of BEAM@leme nts. 联动装置装配如下图所示，连杆3是一个柔性部件，为矩形杆件在ANSY防采用 SOLID45单元构造。ADAM中连接铰将连接在位于杆两端的孔中心接触节点上。 这些节点会通过BEAM单元构造的蜘蛛网格与圆柱铰表面连接。 12.82 Problem Specificatio ns问题说明The figure below shows the Link3 component as it is modeled in ANSYS.Figure 12.6: Li nk3 Compo nentThe follow ing are dime nsions and properties for the Link3 comp onent. 12.82 Problem Specificatio ns 问题说明 The figure below shows the Link3 component as it is modeled in ANSYS. Figure 12.6: Li nk3 Compo nent The follow ing are dime nsions and properties for the Link3 comp onent. 杆3的尺寸及性能如下 Radius of holes (radh) = 6mm 孔径=6mm Width of recta ngular rod (width) = 25mm 矩形杆件宽度=25mm Thick ness of recta ngular rod (thick) = 10mm 杆件厚度=10mm Len gth of recta ngular rod (le ngth) = 300mm + 4*Radius of holes = 324mm 杆件长度=300+4*孔径=324mm 4 Youn gs modulus for rod = 7.22 x 10 MPa 杆的弹性模量=7.22 x 104 MPa Poiss ons ratio for rod = 0.34 杆的泊松比=0.34 -9 3 Density of rod = 2.4 x 10 tons/mm 杆的密度=2.4 x 10-9 tons/mm3 （注意单位是吨/立方毫米） 5 Youngs modulus for beams = 2.1 x 10 MPa 梁的弹性模量=2.1 x 105 MPa （孔内蜘蛛网格是用梁单元构造的） Poiss