卡尔蔡司 笔试题Qualifikationstest.docxVIP

Aptitude Test for Field Service Applicants Carl Zeiss Industrielle Me?technik GmbH Page 1 The decimal number 11 must be converted to a binary number. Which of the following answers is correct? (0144 Tech. Part 3) 1000 1001 1011 1101 A D/A converter generates an output voltage of 1mV if the bit pattern 0000 0001 is applied at its data inputs. Which output voltage occurs with a bit pattern of 0010 0001? (0163 Tech. Part 3) 129 mV 0.101 V 65 mV 0.033V 4. Which unit is labeled ROM in the flow chart Micropro- on the right? (0168 Tech. Part 3) cessor ? read-write memory Data bus ? random memory ? arithmetic unit ROM RAM I/O module read-only memory Page 2 Which memory can not be cleared (erased) electrically? (0181 Tech. Part 3) RAM VRAM EEPROM EPROM Which of the following memory chips requires a refresh cycle? (0187 Tech. Part 3) SRAM DRAM EPROM Flash memory Which signals occur at outputs Z1 to Z4? (0085 Tech. Part 3) Page 3 Which of the following statements about the capacitor on the right is true? (0310 Tech. Part 1) It has a capacitance of 0.1nF Its max. operating voltage is 100 V AC It has a capacitance of 0.1MF It has a capacitance of 0.1mF For what type of capacitors must the polarity of the applied voltage be taken into consideration? (0305 Tech. Part 1) MP capacitors Plastic film capacitors Bipolar electrolytic capacitors Tantalum capacitors (with solid electrolyte In which case does a conducting-state current flow through the silicon diode? (0559 Tech. Part 2) 1 2 3 4 Page 4 General Computer and Data Technology Which statement about the base circuit with operational amplifier on the right is true? (0760 Tech. Part 2) The circuit has a low output impedance The circuit has an amplification A 100 The circuit causes a phase angle rotation of 180 degrees between U1 and U2 The circuit has a low driving point impedance In which line are the switching states of the lamps all correct? Note: 1 = lamp switched on, 0 = lamp switched off (0675 Tech. Part 2) Switch setting