变压器材料五金件检验标准.pdfVIP

中国 3000 万经理人首选培训网站 Inspection standard for hardware material 五金件检验标准 1.0 OBJECTIVE 目的 To define a procedure that provides for acceptance of parts quality by the end user through inspection for a specification time at a specified distance. 建立此程序以确保通过最终客户定时定点的检测后所提供的零部件质量接收要求 . 2.0 SCOPE 范围 The inspection standard is use only for Megapower Shanghai. The hardware material include fixation, metal sheet, lug, earth tappet, connector terminal, mounting rail, screw gland, air gaps, screw, nut, threaded rod, washer, terminal, mounting bracket, mounting plate, copper bar, aluminum bar . 本检验标准仅在上海兆启有限公司使用 . 五金件材料包括装置器，金属片，接线片， 接地杆，连接器端子，装备杆，螺丝管，空气阻隔器，螺丝，螺母，螺杆，垫片，端子， 支架，钢板，铜板，铝板等 . 3.0 DEFINE 定义 Major defects: Point serious impact to the vision and use; And can ’t reach to the design requirement. 主要缺点 : 指严重的影响使用及严重影响视觉 ;及无法达到原设计要求的缺点 ; Min defects: Point impact to vision; And no important dimension according to the ass ’y drawing. 次要缺点 : 指轻微影响视觉及非关键尺寸的缺点 ; 4.0 SAMPLING PLAN AND ACCEPTABLE QUALITY LEVEL 抽样计划和允收水平 4.1 Sampling plan: 抽样计划 According to sampling plan of Megapower shanghai, the sampling grade is divided into: Reduce sampling, normal sampling, increase sampling. 抽样方案按照兆启上海的抽样计划，抽样等级分为：正常抽样，减少抽样，加强抽样。 正常选择抽样比例依照一般检验水准 II 级。 更多免费资料下载请进： 好好学习社 区 中国 3000 万经理人首选培训网站 4.2 Acceptable Quality Level 允收水准 : Major defect for AQL0.65;Min defect for AQL1.5, The sample plan is class two ac