设计说明书 基于单片机的语音识别系统的设计.pdfVIP

  • 228
  • 1
  • 约9.77万字
  • 约 43页
  • 2021-06-18 发布于天津
  • 举报

设计说明书 基于单片机的语音识别系统的设计.pdf

基于单片机的语音识别系统设计 目 录 前言 2 第一章 语音识别系统分析 3 第 1.1 节 语音识别系统结构 3 第 1.2 节 语音设计原理 3 第二章 语音识别系统硬件电路9 第 2.1 节 基于 STC 控制电路 9 第 2.2 节 基于语音处理电路 11 第 2.3 节 基于语音采集模块电路 13 第 2.4 节 语音处理系统电路图 13 第三章 语音识别的实现 15 第 3.1 节 与 PC 机的连接结构 15 第 3.2 节 与语音处理模块的连接 16 第 3.3 节 语音识别软件设计 17 第四章 系统测试22 第 4.1 节 检测结果 22 第 4.2 节 误差分析 23 结论25 参考文献26 致谢 27 附录28 附录 1:实物照片说明28 附录 2:部分源程序28 - i - 【摘要】:设计了一种由说话者说出控制命令,系统进行识别理解,并执行相应动 作的语音识别系统。系统由三个模块——语音采集模块、语音处理模块、单片机判断模 块组合而成。说话者的指令通过咪头采集并送入语音芯片 LD3320 中,接着指令信号与标 准库中的指令比较后,结果被送入单片机 STC11l08x 中进行处理。单片机输出判断结 果,并驱动外部小灯 “亮灭”来显示结果是否正确。该系统与传统相比较,具有结构简 单,抗干扰能力强,使用方便等特点,并且系统智能化程度高,性价比好,运行可靠。 【关键词】:单片机;语音信号处理;c 语言; [Abstract] : Design of a control command from the speaker to say, the identification system to understand and perform the appropriate action based speech recognition system. System consists of three modules - voice acquisition module, voice processing module, microcontroller judgment module combination. Instructions through the speaker into the microphone and the voice chip LD3320 collected for processing, the command signal and standard library instruction comparison, the results are sent to the microcontroller STC11l08x for processing. Microcontroller output judgment results and drive small external lights to show off the results are correct. The system is compared with the traditional, simple structure, strong anti-interference ability, easy to use features and a high degree of intelligence systems, cost-effective, reliable operation. [Key words]: Microcontroller; speech signal processing; c language; 第 1 页 前言 语音识别研究工作开始于 20 世纪 50 年代。1952 年,当时 ATT 的Bell 实验室实现 了第一个可识别十个英文孤立数字的语音识别系统Audry 系统。 20 世纪 60 年代,计算机的应用推动了语音识别的发展。这时期的重要成果是提出了 动态规划和线性预测分析技术,其中后者

文档评论(0)

1亿VIP精品文档

相关文档