以太网端口浪涌ESD测试方法与标准SurgeESDtestonEthernetport.docx

文档密级 文档密级 第 PAGE 第 PAGE #页.共7页 文档密级 文档密级 第 PAGE 第 PAGE #页.共7页 Specification of Surge ESD test of Ethernetport Referred standard IEC61000-4-5 (2005) Electromagnetic compatibility (EMC) Part 4:Testing and measurement techniques Section 5:Sruge immunity test IEC61000-4-2 (2001) EC61000-4-2： Electromagnetic compatibility -Part 4-2:Testing and measurement techniques-Electrostatic Discharge immunity test (2001) Test equipment and waveform Characteristic of surge combined waveform and equipment Surge combined waveform Characteristic of surge test waveform is: 1.2/50卩s( 8/20ps) combined waveform. Combined waveform generator (CWG) is the equipment which can generate open circuit voltage of 1.2/50卩s, short-circuit current of 8/20卩s. Rising time: T1 = 1.67xT=1.2ps±30%, half amplitude time: T2=50ps±20% Figure 1 open circuit voltage waveform (1.2/50ps), according to IEC60-1 文档密级 文档密级 第 PAGE 第 PAGE #贝.共7页 文档密级 文档密级 第 PAGE 第 PAGE #贝.共7页 2.2 2.2 2.2.1 Rising time: T1 = 1.25xT=8ps±20%, half-amplitude time: T2=20jjs±20% Figure 2 short-circuit current waveform （8/20卩s）, according to IEC60-1 Characteristic of ESD waveform and equipment ESD waveform Figure 3 ESD waveform 2.3 Equipment used in H3Clab Table 2 equipment used in H3C lab Equipment P/N vendor Series SURGE high voltage pulse generator PSURGE8000 HAEFELY 153126 SURGE waveform generator PIM100 HAEFELY 153107 4 wire communication port CDN PCD121 HAEFELY 153682 4 wire communication port CDN IP6.2 HAEFELY 150858 ESD gun PESD1610 HAEFELY H 505595 Test setup Common mode surge test setup Referring IEC61000-4-5 Figure 14。 文档密级 文档密级 第 PAGE 第 PAGE #贝.共7页 文档密级 文档密级 第 PAGE 第 PAGE #页.共7页 CQlculotion of Rm2 when using GWG (1,2/50 (js generator) Example for n = 4: Rm2 = 4 x 40 □ = 160, max. 250 Q Calculation of Rm2 when using CWG (10/700 “s generator) The internal matching resistor Rm2 (25 Q) is replaced by external Rm2 = n x 25 Q per conducror (for n conductors with n equal or greater than 2). Example for n = 4: /?rn2 = 4