机用虎钳逆向设计及运动仿真.docxVIP

机用虎钳逆向设计及运动仿真 摘要：逆向工程作为近年来迅速发展的快速设计制造技术的重要分支，可大大缩短产品制造周期，因而在制造领域得到了广泛的应用。本文通过研究机用虎钳的逆向设计过程，来了解逆向工程的概念、方法以及逆向设计的整个工作流程。具体过程是通过采用三坐标测量机对机用虎钳进行测量扫描，建立机用虎钳的三维模型；然后根据机用虎钳的原始模型来进行改良，对产生问题的模型进行直接的修改和分析；然后再根据修正后的模型通过PRO/E软件绘制出最终的三维模型，并采用PRO/E对模型进行运动仿真，最后绘制机用虎钳的装配图和零件图，此方法有效地解决了机用虎钳难以精确测量的问题。与传统的正向设计方法相比,该方法提高了工作效率,缩短了新产品的开发周期。 关键词：逆向工程，PROE，建模，运动仿真 Reverse design and movement simulation of machine vice Abstract：As an important branch of?rapid design?in recent years the rapid development?of manufacturing?technology of reverse engineering,?which can?greatly shorten the product?manufacturing cycle,?so it is applied widely?in the manufacturing field.This paper?machine with?reverse design process?of vice,?to?understand the concept,?the method of reverse engineering?and reverse?design of the entirework process.?Specific process is?through the use of?three coordinate measuring instrument of?machine vice?were measured by?scanning,?establish the three-dimensional model of?the machine vice.?Then?according to the original model?toimprove?the machine vice,?through?modification,?testing and analysis?of?the?modeldirectly.?The?machine?working principle?of vice,?characteristics?of?the main parameters?of the?machine?vises,?design?of?machine?parts,?the structure size?of vice?calculate correctly,?get relatively?ideal result,?then according to?the modified model?by?PRO/E?software to draw the?three-dimensional?model of?the final,?and uses PRO/E?simulation exercise?the model,?finally drawing?machine?assembly?viceand parts diagram,?this method effectively solves the?machine vice?difficult to measure accurately?the problem.?Compared with the?traditional top-down design method,?this method?improves the work efficiency,?shorten the?development cycle of new products. Keywords: Reverse engineering,PROE, Modeling, Motion simulation 目 录 TOC \o 1-3 \h \z \u 1 前言 1 2 逆向工程和三坐标测量机 2 2.1 概述 2 2.2 逆向工程 2 2.2.1 逆向工程的定义 2 2.2.2 逆向工程的应用领域 4 2.2.3 逆向工程在国内外研究状况 6 2.3 三坐标测量机 6 2.3.1 三坐标测量机