奥迪A6维修课件——新型照明系统 标准培训.pptVIP

TI Contents X * * * * * * * * Changing bulbs is possible for parking, high beam and dipped  beam headlights but on the right side the air filter box has to be removed. Turn signal lamps are accessed via the KD opening in the  wheel well liner. Pay attention to the neutral position of the manual headlight  levelling controller when setting the headlights. It is necessary to have an Audi Original Condition sticker  when driving in countries with left-hand traffic. When removing the headlights it is necessary to disassemble the bumper overlay. To avoid electrostatic charge and attraction of dust particles,  do not clean headlights with a dry rag. For further information see the SSP 326 A6 2005 Electrics. * Changing bulbs is possible for parking, high beam and dipped beam headlights but on the right side the air filter box has to be removed. Turn signal lamps are accessed via the KD opening in the  wheel well liner. When setting the headlights the dynamic headlight levelling  controller must be brought to its original setting with the VAS tester. Furthermore, for vehicles with adaptive light 2, the showroom function headlight setting is deactivated. The headlight can be adjusted for driving in countries  with left-hand traffic. When removing the headlights it is necessary to disassemble the bumper overlay. To avoid electrostatic charge and attraction of dust particles,  do not clean headlights with a dry rag. Bulbs marked with a * are new in the programme. Please inform  your parts service employees of this. For further information see the SSP 326 A6 2005 Electrics. * Basic and high variant lamp holders are identical. Light diodes are firmly anchored in the reflector housing. Inform parts service of the differing reflector housings. It is possible to change the bulbs after removing the reflector housing. Light diodes cannot be replaced. If a light diode fails, switch off all light diode electrics; the failure will be reco