参考讲稿发给17年大学生1.pptx

Specific J1939 Messages;Acronyms;Resouces;pgn0 - TSC1Torque Speed Command;pgn0 – TSC1 – Torque Speed Command;pgn0 – TSC1 – Torque Speed Command;spn695 spn897 – Override Control Mode and Priority;spn898 – Speed Limit/Control;spn518 – Torque Control/Limit;Scenarios;DM1 - Active Fault Code Message;J1939 has several different messages which contain diagnostic (fault) code information. Diagnostic Message 1 - DM1 - Active Fault Codes Diagnostic Message 2 - DM2 - Inactive Fault Codes Diagnostic Message 3 - DM3 - Clear Inactive Fault Codes Typically customers will use the DM1 message to detect when a fault code has gone active. The DM1 message is PGN 65226 or FECAh. Information about this message is in J1939-73. ;Breakdown of PGN 65226;DM1 – Byte1 – Lamp Status;DM1 – Bytes 3 - 5;DM1 - Byte 6 Bit 8 – Conversion Bit;SPN - Conversion Method 0;SPN - Conversion Method 1;DM1 – Byte 6, Bits 1 – 7 Occurrences;;;FMI Code Description 0 Data Valid but above Normal Operating Range 1 Data Valid but below Normal Operating Range 2 Data Erratic, Intermittent or Incorrect 3 Voltage above Normal or Shorted to High Source 4 Voltage below Normal or Shorted to Low Source 5 Current below Normal or Open Circuit 6 Current above Normal or Grounded Circuit 7 Mechanical System Not Responding or out of adjustment 8 Abnormal frequency or pulse width or period 9 Abnormal Update Rate 10 Abnormal Rate of Change 11 Root Cause Not Know 12 Bad Intelligent Device or Component 13 Out of Calibration 14 Special Instructions 15 Data Valid But Above Normal Operating Range (Least Severe Level) 16 Data Valid But Above Normal Operating Range (Moderate Sever Level) 17 Data Valid But Below Normal Operating Range (Least Severe Level) 18 Data Valid But Below Normal Operating Range (Moderate Severe Level) ;J1939 Transport Message;J1939 Transport Message;TP.BAM Message;pgn60416 – Connection Management;pgn60160 – Data Transfer;TP.BAM Dat