毕业设计(论文)-年产15万吨pvc全工段工艺设计【全套图纸】.pdfVIP

摘 要 本设计采用电石法、悬浮法聚合生产PVC。对年产15万吨聚氯乙烯(PVC)全工段工艺 设计，进行了乙炔段物料衡算、氯乙烯合成物料衡算、聚合段物料衡算、汽提段物料衡算、 离心干燥段物料衡算和乙炔段热量衡算、氯乙烯合成热量衡算、聚合釜热量衡算。得出本 3 3 次设计需采用九个48 （Ⅱ型）不锈钢聚合釜并联操作，五台70 出料槽，21 台WL-630 m m 型离心机。同时绘制了带控制点的PVC合成工艺流程图、带控制点的PVC汽提工艺流程 图、聚合工段主要设备平面布置图、聚合工段主要设备立面布置图以及聚合釜装配图等。 全套图纸，加 153893706 关键词：聚氯乙烯；电石法；悬浮聚合；聚合釜；工艺流程 word文档 可自由复制编辑 Abstract This design uses calcium carbide method, suspension polymerization of PVC. Of the annual output o 150,000 tons o PVC (PVC) full section in process design, carried out acetylene segment material balance, material balance synthesis of vinyl chloride polymerization section o material balance, stripping section mass balance, material balance centrifugal drying section Operators and acetylene segment heat balance, heat balance o vinyl chloride synthesis, polymerization reactor heat balance. This design requires the use o derived 9 48 ( Ⅱtype) stainless steel polymerization reactor operating in parallel, five 70 trough, 21 units WL-630 centrifuge. Control points are drawn with the PVC synthetic process flow chart, with the control point flow chart of PVC stripping the polymerization section in the main equipment floor plan, elevation polymerization Section of major equipment layout and assembly drawings and other polymerization reactor. Keywords：PVC ；calcium carbide process；suspension polymerization ； word 文档 可自由复制编辑 polymerizing pot ；process flows 目 录 摘 要 I Abstract II 目 录 III 第一章 文献综述 1 1.1聚氯乙烯的性质2 1.1.1物理性质 2 1.1.2化学性质 2 1.1.3聚氯乙烯的用途 3 1.2聚氯乙烯生产工艺介绍4 1.2.1世界聚氯乙烯工艺技术进展 4 1.2.3 国内聚氯乙烯工业技术进展4 1.3聚氯乙烯生产方法及工艺流程的介绍 5 1.3.1