ASTM-A924课件课件课件.docx

PAGE PAGE 1 Designation: A 924/A 924M – 04 Standard Specification for General Requirements for Steel Sheet, Metallic-Coated by the Hot-Dip Process1 This standard is issued under the fixed designation A 924/A 924M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. Scope* This specification covers the general requirements that, unless otherwise specified in the product specification, apply to steel sheet in coils and cut lengths, metallic-coated on continu- ous lines by the hot-dip process. The product is intended for applications requiring corrosion resistance. The product speci- fications contain requirements for specific strength levels, heat resistance, paintability, or formability, or a combination thereof. Subject to individual product specification provisions, steel sheet is available as Commercial Steel (CS) Types A, B, and C, Forming Steel (FS), Drawing Steel (DS), Deep Drawing Steel (DDS), Extra Deep Drawing Steel (EDDS), High Tem- perature Steel (HTS), Structural Steel (SS), and High Strength Low Alloy Steel (HSLAS). Steel sheet is produced with the following metallic coatings. Specific information on each of the following is contained in the individual product specifica- tion: Zinc or zinc-iron alloy coated, Zinc-5 % aluminum alloy coated, 55 % aluminum–zinc alloy coated, Aluminum–coated, and Terne (lead-tin alloy) coated. Products covered by this general requirements specifi- cation are described in the following product standards: Speci- fications A 308; A 463/A 463M; A 653/A 653M; A 755/ A 755M; A 792/A 792M; A 875/A 875M; and A 929/A 929M. Metallic-coated steel sheet is produced to various coat- ing designations, as shown in the individual product specifica- tions. Except for differentially coated