机械毕业设计45T旋挖钻机变幅机构液压缸设计(含外文翻译).docxVIP

目 录 TOC \o 1-5 \h \z 引言 1 第1章 绪论 \o Current Document 旋挖钻机简介 4 \o Current Document 本设计的主要内容 5 第2章 液压缸 \o Current Document 液压缸简介 6 液压缸类型 6 液压缸工作原理 8 \o Current Document 液压缸的组成 9 第3章 液压系统设计 \o Current Document 液压系统的确定 14 \o Current Document 液压系统的设计要求 14 \o Current Document 液压缸的设计计算 15 第4章 液压系统保养 \o Current Document 4.1 旋挖钻机液压系统的保养 32 致谢 35 参考文献 36 \o Current Document 附录 37 45T旋挖钻机变幅机构液压缸设计 内容摘要: 本文主要介绍了旋挖钻机变幅机构液压缸的设计。液压缸的设计包括了系统工作压力 的确定、液压缸活塞直径的确定和活塞杆直径的确定、 液压缸壁厚和外径的计算、缸盖厚度 的确定、缸体长度的确定以及活塞杆稳定性的验算。 本文结合传统设计和计算机辅助工程技 术，先依据经验公式计算，确定了液压缸安装方案，设计了液压缸活塞及活塞杆尺寸参数， 校核了匹配的连接螺栓，销轴等；完成了变幅及变角度液压缸的设计计算。然后利用 AutoCAD, Pro/Engineer辅助设计平台，完成了液压缸所有零件的二维及三维建模。通过分 析的数据校核了先前的设计，同时为进一步优化设计和系列化设计提供了依据。 关键词： 变幅液压缸，变角度液压缸， AutoCAD，Pro/Engineer 45T spiral drill luffing mechanism design of hydraulic cylinder Content abstract: This desig n is mainly in troduced the rotati ng drill luffi ng mecha nism desig n of hydraulic cylinder. The design of hydraulic cylinder including ensure pressure system of the hydraulic cyli nder pist on, pist on rod diameter and the diameter and wall thick ness and diameter of hydraulic cyli nder cyli nder, the thick ness of the calculati on of the len gth, and the cyli nder pist on rod stability of calculati on. In this thesis, by the use of traditional design and computer-aided engineering (CAE) , firstly based on experienee of the formula calculation to determined the installation scheme of the hydraulic cylinder, design size parameters of hydraulic cylinder piston and piston, Check the matchi ng of connecting bolts, pin shaft, etc.;complete the desig n and calculation of the range and angle of hydraulic cylinder. Then by the use of AutoCAD,Pro / MECHANICA platform, Complete all parts of the hydraulic cyli nder 2d and 3d modeli ng.The an alysis data verificated the previous desig n, at the same time ,applied refere nces for further Optimal Desig n and Series Desig n. Keywords: The luffing hydraulic cylinder， Variable Angle of hydraulic cy