模具术语中英文对照.docx

AD-Diameter The tread diameter at the cen terli ne of the tread (EU); also: T-Diameter(GT) AD 直径：指胎面中心线直径 (EU。又叫 T 直径(GT Auto-lock Ear A Lug on the cone ring used to mount the mold/c ontainer in the top half of a 60 Auto-lock press. 导环上的突缘，用于和 60 “ NRMAuto-lock 硫化机上半部连接。 Bead Ring The tire bead forming ring (also: toe ring) 钢圈，也称 toe ring Bead Ring Register The landing and tapered seat that the bead ring fits into 钢圈配合：侧板上，和 钢圈配合的平面及锥面 Bottom Container Plate The plate that the bottom sidewall plate is bolted to 模壳底座 Bottom Container Plate Lifti ng Lug A lug attached to the Bottom Container Plate with Horiz on tal holes used for lifti ng. 模壳底座吊耳： 装配在底座上、有水平的孔，用来吊装的吊耳 Bottom Container Plate Dowel Pin Lug A lug attached to the Bottom Container Plate that supports the Dowel Pin Bushi ng. 装配在底座上，用来支承定位销套的突缘 Bottom Container Plate Hold DownA lug that is used to fix the Bottom Plate in the Press. 用来将底座装配在硫化机上的突缘 Breaker Hook A hook fixed to the bottom of the tread segment that catches the bottom container plate only whe n the segme nt will not release from the tire duri ng de-moldi ng. 分离钩：固定在花纹块底部的钩子，轮胎硫化完后若花纹块不能跟轮胎分离，就用此钩抓住模壳 纹块和轮胎进行分离。 Breaker Hook Guide Piece A block bolted to the breaker hook that aligns the tread segment with a slot in the bottom container plate. 分离钩导块：用螺栓固定在 Breaker Hook 上，定位花纹块和模壳底座上槽的定位块。 Bronze Wear Plates Any sacrificial metal plate placed under, over or behind a component to keep the comp onents from weari ng on each other (greas ing) “ NRM 底座帮助花 青铜耐磨板 （油润滑的 ） Casti ng An un-mach ined cast metal tread ring or Segme nt 铸件：未加工的金属花纹圈或花纹块铸件。 Centering Ring The ring mounted on the bottom press platen to locate the mold/ container concen trically to the press; also: Press register 定中环 ,也称“ Press register ” Clamp Rings The bladder clamping assembly 胶囊夹盘 Cone Ring The outer ring that transforms the axial movement of the press in a radial one of th