毕业论文-基于STM32的酒店客房智能控制系统设计与实现.doc

PAGE II 武汉理工大学毕业设计（论文） 基于STM32的酒店客房智能控制系统 设计与实现 学院（系）： 信息工程学院 专业班级： 通信1105班 学生姓名： 指导教师： 摘 要 随着信息化时代的到来，智能化系统正在应用于我们日常生活中的各行各业，智能酒店作为智能家居系统的一个分支行业，也得到了全面的发展。智能酒店利用网络通信技术、现场总线通信技术等对酒店内的相关设备进行统一的控制与管理。 目前市面上主流的酒店客房控制系统都是采用触摸面板来控制房间内的灯光、音乐等，无法满足智能酒店信息与网络化的特点。针对于以上情况，本文设计并实现了一种基于CAN总线通信技术与TCP/IP网络通信技术来对酒店客房内的灯光、音乐、电器等进行智能控制的系统。 本文详细描述了系统的总体方案设计架构，系统各个子模块的硬件电路设计与实现，硬件设计以STM32单片机为核心控制处理器，各个子模块通过CAN通信接口进行数据的传输与互联。系统软件设计中确定了客房控制系统中的通信方式以及通信协议，同时完成了各个硬件对应的底层驱动程序实现。最后利用系统的软硬件平台，搭建了酒店客房控制模型，并在此客房模型中对所设计的控制系统进行了各个子模块的功能性测试以及系统完整性测试，测试结果表明本系统能够满足与当前酒店智能化的需求。 关键词：酒店 STM32 智能控制 CAN Abstract With the advent of the era of information technology, intelligent systems are applied to all walks of life in our daily life, smart hotel as a branch of smart home system industry, also obtained the comprehensive development.Smart hotel is a comprehensive utilization of the computer technology and Internet communication technology and automation control technology related equipment in the hotel for the unified control and management. Currently on the market mainstream hotel rooms control system are the touch panel is used to control the room lights, music, etc., cannot meet the smart hotel information and the characteristics of the network.Based on the above situation, this paper designs and realizes a kind of based on CAN bus communication technology and TCP/IP network technology to the hotel guest room lights, music and electrical appliances intelligent control system. This paper describes the overall design of system architecture, system hardware circuit design and implementation of each module, hardware design with STM32 MCU as the core control processor, each module through the CAN communication interface for data transmission and interconnection.Identified in the design of system software in the guest room control system communication mode and communication protocol, at the same time completed each corresponding underlying hardware dr