美国球阀厂家说明-13.pdf

Installation Operating Instructions Ball Valve EK, FK, HK Installation ARGUS After completion of the assembly - before the ball valve is actuated - a flushing must be carried out. If pipework forces are transferred to the valve, then the design must be inquired with the manufacturer accordingly. If the ball valve is used for permanent shut-off from the atmosphere, a blind flange or equivalent end must be provided. 5.3 Installing Welded Connection DANGER Special requirements for welding pressure-loaded pipework: Local welding regulations, provisions, instructions and specifications as well as the special safety requirements must be observed when welding. Welding work may only be carried out by qualified personnel with appropriate protective equipment. 1. Transport the ball valve to the assembly location using suitable lifting devices which are appropriate to the weight and the size of the ball valve (053-01) 2. Remove protective caps (053-02) 3. Clean the pipework connection and the welding ends of the valve, remove paint and rust in the area of the welded joint - create a clean metallic surface (053-03) 4. Welding the first end: Ensure correct placement and correct alignment of the ball valve between the pipework connections! (053-04) In the case of short welding ends, there is a risk that soft seats can be damaged by excessive heat. The temperature of the valve body in the seat area must be monitored using thermometer strips during the welding works. Maximum perm