eCPRI Specification V1.1 (2018-01-10) eCPRI规范V1。1 (2018-01-10)中英文对照.pptx

eCPRI Specification V1.1 (2018-01-10) eCPRI规范V1。1 (2018-01-10)中英文对照.pptx

  1. 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
eCPRI Specification V1.1 (2018-01-10);2;CPRI;CPRI;CPRI;6;CPRI;8;CPRI;10;11 eCPRI Specification V1.1 (2018-01-10) 用户平面数据(即 eREC 和 eRE 中的分离 PHY 层功能之间的信息流及其实时控制),控制 和管理以及同步信号通过传输网络(前传网络)进行打包,复用和传输,其中 eREC 和 eRE ( s)连接到。 eCPRI does not constrain the use of network-layer and data link-layer protocols to form the network, so any type of network can be used for eCPRI provided eCPRI requirements (defined in [15]) are fulfilled. eCPRI also uses existing de-facto/de-jure standard protocols as much as possible where available. The basic idea is illustrated in Figure 1. eCPRI 不限制使用网络层和数据链路层协议来构成网络,因此任何类型的网络都可以用于 eCPRI 提供的 eCPRI 要求(在[15]中定义)得到满足。 eCPRI 还尽可能使用现有的事实上/法 律上的标准协议。 基本思想如图 1 所示。 Figure 3 shows an example of a system architecture with local eCPRI. eCPRI is used as an internal interface within the eREC and/or eRE (local eCPRI) when the eREC/eRE consists of multiple eREC/eRE elements. In addition, eCPRI and CPRI can coexist in a system. Please note that eCPRI has no backward compatibility with legacy CPRI. 图 3 显示了具有本地 eCPRI 的系统架构的示例。 当 eREC / eRE 由多个 eREC / eRE 元素组成 时,eCPRI 用作 eREC 和/或 eRE(本地 eCPRI)内的内部接口。 此外,eCPRI 和 CPRI 可以 在一个系统中共存。 请注意,eCPRI 与传统 CPRI 没有向后兼容性。;12 eCPRI Specification V1.1 (2018-01-10) 两个节点重命名为 eREC 和 eRE 的变化很小。 这两个节点之间的功能划分可以比 CPRI 规范 更灵活地概述。 表 1 中列出了 eNB / gNB(eREC 和 eRE)的功能内容,表中包括对相应 3GPP 技术规范的参考。 Table 1: Functional content of eNB/gNB;198 Figure 5: Functional decomposition on RAN layer level As shown in Figure 5 the eNB/gNB consists of only two units: the eREC and the eRE. For some of the splits an implementation with only two nodes may not be realistic. For instance, Split A with a central RRC and a distributed unit containing the rest of the protocol stack would not support a number of features (such as those requiring cell-coordination) efficiently. eCPRI assumes that the eNB/gNB consists of eREC and eRE(s) only and thus the following text should be read with this in mind. The intra PHY Split is marked with a red line, this is just an example show

您可能关注的文档

文档评论(0)

分享吧 + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档