omniscan12-楔块延迟校准.pdf

OmniScan MX2 Training Program OmniScan MX2 培训 Wedge Delay Calibration Wizard 楔块延迟校准向导 OmniScan MX2 Training – Wedge Delay Wizard Overview OmniScan MX2培训——楔块延迟向导概述  The wedge delay calibration wizard is designed to measure and offset the sound propagation between the probe and the exit point of the focal law in the wedge. (54.97usec below)  楔块延迟校准向导用于测量和补偿探头和携款中聚焦法则输出点之间的声传播。  The function is exactly the same as conventional UT with the exception that all the variables are available to mathematically calculate it when exiting the setup group wizard and the function is performed on many A-scans or focal laws at the same time instead of just one.  本功能与常规UT完全相同，除了当退出设置组向导时所有变量可进行数学计算，以及同时对许多 A-扫描或聚焦法则进行操作而不是仅一个。 2 OmniScan MX2 Training – Wedge Delay Wizard Overview cont. OmniScan MX2培训——楔块延迟向导概述  When the wedge delay is set correctly, 0mm on the A-scan corresponds to the exit point of the wedge.  当楔块延迟正确设置是，A-扫描上的0mm相当于楔块的输出点。  The sound path propagation through the wedge is delayed out of the A-scan.  声程通过楔块的传播不含在A-扫描中  Every focal law has a different wedge delay due to the different angles and exit point on the wedge.  因为楔块上的不同角度和输出点，每个聚焦法则有一个不同的楔块延迟。  Inaccurate wizard input for wedge and probe parameters or failure to calibrate the wedge delay when needed results in inaccurate time of flight and depth readings. (SA and DA)  楔块和探头参数错误的向导输入或必要的楔块延迟校准失败，产生错误的渡越时间和深度读数。 A-扫描0mm位置 50mm声程（SA）读数 0mm 3 OmniScan MX2 Training – Wedge Delay Wizard Overview cont. OmniScan MX2培训——楔块延迟向导概述  Inputting the wedge, probe, and component parameters correctly into