omniscan19-相控阵波幅分析.pdf

OmniScan MX2 Training Program OmniScan MX2 培训 Phased Array Amplitude Analysis 相控阵振幅分析 OmniScan MX2 Training – Amplitude Analysis Overview OmniScan MX2培训——振幅分析概述  The majority of both conventional and phased array weld inspections can be considered “Amplitude based” inspections as opposed to time of flight applications like TOFD, corrosion mapping, and composite inspections.  大多数常规和相控阵焊缝检测可被认为是“基于振幅的”检测，与渡越时间应用如TOFD、腐蚀测绘和复 合材料检测相对。  Using side drilled holes (SDH) or notches of different size at different depths a reference sensitivity can be calibrated for comparison to detected flaws during the inspection. Typically to 80%.  使用不同深度不同尺寸的切口或横孔（SDH），检测中对比检测缺陷可校准参考灵敏度。  The smaller the notch or SDH, the more gain required resulting in a more sensitive inspection and greater potential for a reject.  切口或SDH越小，要求的增益越大，引起一个更灵敏的检测和更可能不可接受。  Amplitude analysis is dependent on the data having been acquired in accordance with the calibration and inspection rules specified in the referencing code or procedure.  振幅分析取决于按照参考规范或程序指定的校准和检测规则获得的数据。  The MX2 uses an 8 bit amplitude resolution (0-100%) for the digitized A-scan and a 10 bit resolution (0-200%) for the C-scan gate data and gate readings.  MX2数字化A扫描使用8位振幅分辨率（0-100%），C扫描门数据和门读数使用10为分辨率（0-200%）。  Modifying the gate position in analysis mode will convert 10 bit data to 8 bit data where only 0-100% amplitude is available. In other words, when you change the gate position all data between 101- 200% is converted to 100% amplitude.  在分析模式中修改门位置将10位数据转换为仅0-100%可用的8位数据。也就是说，当你改变门位置时， 所有101-200%之间的数据转换为100%振幅。 2 OmniScan MX2 Training – Amplitude Analysis – A% Readings OmniScan MX2培训——振幅分析——A%读数  The A% reading is the peak amplitude detected in gate A.  A%读数是门A 中检测到的峰值振幅。  The