omniscan18-相控阵整体分析.pdf

OmniScan MX2 Training Program OmniScan MX2 培训 Phased Array Analysis Overview 相控阵分析概述 OmniScan MX2 Training – Analysis Overview MX2培训—分析概述  The phased array analysis section is divided into the following tasks or measurements:  相控阵分析由以下部分组成： – Amplitude analysis. 振幅分析 – Length sizing. 长度度量 – Depth and height sizing. 深度和高度度量 – Volumetric position. 体积定位 – Flaw characterization. (Geometry, crack, LOF, IP, porosity, etc) 缺陷特征（形状、缺陷、LOF、IP、孔隙等）  Depending on the procedure or referencing code, one or more of the above are required to make an accept\reject decision.  根据不同的程序或引用代码，上述的一个或多个部分可用于作为接受\拒绝的判据。  Both the type of analysis required and the level of precision are directly related to the inspection setup, up front engineering, calibration criticality, and ultimately cost.  所需的分析类型和精度等级均与检测设置、准备工程、临界校正以及最终成本直接相关。  Position C-scan analysis is covered in specific sections for corrosion mapping and composite inspection.  位置C扫描分析包含在腐蚀测绘和复合检测的专用章节中。 2 OmniScan MX2 Training – Analysis Overview cont. MX2培训—分析概述  The AWS D1.5 inspection is an example of an inspection code that only requires amplitude and length sizing for an indication determined not to be geometry. See AWS section for more details. AWS D1.5  检测是一个仅要求进行振幅和长度测量而不需要几何测量的检测规范的示例。 3 OmniScan MX2 Training – Analysis Overview cont. MX2培训—分析概述  The phased array analysis consists of the following tasks and measurements:  相控阵分析由以下部分组成： – Amplitude analysis.振幅分析 – Length sizing.长度度量 – Depth and height sizing.深度和高度度量 – Volumetric position.体积定位 – Flaw characterization.缺陷特征  ASME sec VIII Div. 2 pressure vessel inspection is an example of an