omniscan22-相控阵缺陷位置分析.pdf

OmniScan MX2 Training Program OmniScan MX2 培训 Phased Array Analysis Flaw Volumetric Position 相控阵分析 缺陷提及位置 OmniScan MX2 Training – Analysis – Flaw Volumetric Position Overview OmniScan MX2 培训——分析——缺陷体积位置概述  Flaw volumetric position is defined as the position of the flaw relative to the weld or component.  缺陷体积位置是指与焊缝或组件相关的缺陷位置。  For weld inspection it is is typically expressed as negative or positive in relation to the weld centerline or weld reference, and SWLF flaw on weld overlay either embedded, connected to the ID, or connected to the OD.  对于缺陷检测，它通常表示为负或正涉及到焊缝中心线或焊缝参考， 焊缝覆盖图上的SWLF缺陷 且要么嵌入连接到ID，要么连接到OD。  The flaw volumetric position is a key indicator for determining what type of defect has been detected. (Slag, porosity, IP, LOF, Sk90 (-) Sk270 (+) ext.)  缺陷体积位置是确定检测到的缺陷类型的关键指示。（熔渣、空隙、 IP、LOF等）  Knowledge of the weld bevel and weld process is extremely Weld helpful. In a V weld, IP would occur in the bottom root area, Centerline obviously. In a X weld IP would occur in the weld center.  焊缝斜面和焊接过程的指示是非常有帮助的。在V形焊缝中，IP将明 显地出现在在底面根部区域。在X 形焊缝中，IP将出现在焊缝中心。  Regardless if volumetric position is a requirement of the referencing code, knowing the volumetric position is necessary to make the repair. Where to excavate and how deep and long?  无论体积位置是否为参考规范的要求，知道体积位置对于修补是必 需的。在哪里开挖，多长，多深？ 2 OmniScan MX2 Training – Analysis – Flaw Volumetric Position – Overlay OmniScan MX2 培训——分析——缺陷体积位置——覆盖图  Weld overlays are the primary indicator for determining volumetric flaw position.  焊缝覆盖图是确定体积缺陷位置的基本指示。  Using the part and weld wizard almost any symmetrical or asy