- 1、本文档共21页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
OmniScan MX2 Training Program
OmniScan MX2 培训
Phased Array
Beam Verification using IIW Block
使用IIW试块进行相控阵波束验证
OmniScan MX2 Training – IIW Beam Verification Overview
OmniScan MX2 培训——IIW波束验证概述
This procedure is designed for verifying the beam angle, beam exit point, and beam wedge delay manually
using an IIW block.
本程序用于使用IIW试块手动验证波束角度、波束输出点和波束楔块延迟。
This is useful for troubleshooting beam quality, problems with the calculated wedge delay, time of flight and
angle error, or when the calibration wizard is not returning desired results.
这对检修波束质量、楔块延迟计算值、渡越时间和角度误差或校准向导没有返回期望结果时的问题是有用的。
Use of common calibration blocks like the IIW are the fastest and most reliable method of
troubleshooting…..just like conventional UT.
常见校准试块如IIW的使用是最快最可靠的检修方法。
For any A-scan or focal law, basic beam parameters are measured and verified against the software so you
can be sure that the focal law calculator has
returned the beam you programmed.
任何A扫描或聚焦法则,根据软件测量并验证基本
波束参数,这样你能够确定聚焦法则计算器返回
的波束是你规划的。
2
OmniScan MX2 Training – IIW Beam Exit Point Verification
OmniScan MX2 培训——IIW波束输出点验证
Trouble shooting a suspect focal law starts with verification of the beam exit point.
对一个可疑的聚焦法则进行故障检修从波束输出点的验证开始。
Does the beam exit the wedge where the software predicted?
波束是从软件预测的楔块上的点输出的么?
Select the focal law on the A-scan view and peak the signal using the green envelop. (Use envelope function key or select at
DisplayOverlayA-scanEnvelope
选择A扫描视图上的聚焦法则,使用绿色包络达到信号最高点(使用包络功能键或在“显示覆盖图A扫描包络”中选择)
From the peaked position make a non permanent mark on the wedge where it lines up with the exit reference on the IIW. (Red
arrow left)
从峰值位置,在楔块上与IIW上输出参考对齐的位置标记一个暂时的记号。
Wedge exit point
reference on IIW
block
100m
IIW试块上楔块
您可能关注的文档
- omniscan2-操作界面介绍.pdf
- omniscan6-波束形成基础.pdf
- omniscan9-聚焦法则向导.pdf
- omniscan12-楔块延迟校准.pdf
- omniscan18-相控阵整体分析.pdf
- omniscan19-相控阵波幅分析.pdf
- omniscan20-相控阵缺陷长度分析.pdf
- omniscan21-相控阵缺陷高度分析.pdf
- omniscan22-相控阵缺陷位置分析.pdf
- omniscan23-相控阵缺陷类型分析.pdf
- 新的一年工作展望.docx
- 医生年终个人工作的述职报告(3篇).docx
- 2023年消防设施操作员之消防设备中级技能考前冲刺练习题附答案详解.docx
- 2022-2023年环境影响评价工程师之环评技术导则与标准通关练习题包括详细解答.docx
- 2023年中级注册安全工程师之安全生产管理考前冲刺检测卷和答案.docx
- 2023年中级银行从业资格之中级银行管理考前冲刺测试卷提供答案解析.docx
- 2023年公共营养师之二级营养师通关模拟考试试卷附带答案.docx
- 证券分析师之发布证券研究报告业务考前冲刺模拟题库.docx
- 2022-2023年二级建造师之二建建设工程法规及相关知识综合提升测试卷附答案.docx
- 2023年二级建造师之二建机电工程实务通关模拟考试试卷提供答案解析.docx
文档评论(0)