MS200-41硫化橡胶分析和总结.docxVIP

SCOPE OF APPLICATION SHT/SHTS ALL ESTABLISHED POLYMERIC MATERIALS RESEARCH TEAM TITLE:  ENGINEERING STANDARD MATERIAL SPECIFICATION TEST STANDARD – SOFT VULCANIZED RUBBER CONTENTS SCOPE TEST ITEMS GENERAL TEST CONDITIONS 1/58 SPEC No. MS 200-41 TESTING HARDNESS TEST TENSILE TEST AGING TEST COMPRESSION SET TEST OIL RESISTANCE TEST TEAR RESISTANCE TEST OZONE RESISTANCE TEST COLD SHORTNESS TEST BEND TEST IMPACT RESISIENCE TEST LOW ELONGATION STRESS TEST METAL ADHESION TEST PEEL STRENGTH TEST PERMANENT EXTENSION SET TEST OTHERS a EMS40706 RETYPING ALL 11.23.04 H.O.KIM 870708 ISSUE OF ENGLISH SPECIFICATION ALL JUL.08.87 SYM EO NO DESCRIPTION OF CHANGE REV.PAGE REV.DATE REV.BY PREPAREDCHECKEDAPPROVED PREPARED CHECKED APPROVED BY BY BY SIGNED SIGNED SIGNED H.O.KIM B.K.MIN T.W.HWANG 11-18-04 11-18-04 11-22-04 HYUNDAI KIA MOTOR ORIGINAL FILED AT IPIS (ES/MS MANAGEMENT SYSTEM) 1F-SG-00016 REFERENCE ENGINEERING STANDARD (SPEC NO) MS 200-41 (SHT/SHTS) 2/58 Scope This specification applies to the test standard required to specify the quality of soft vulcanized rubber. Test Items The test items required in this specificaton shall be listed as follows : Hardness Test Tensile Test Aging Test Compression Set Test Oil Resistance Test Tear Resistance Test Ozone Resistance Test Cold Shortness Test Bend Test Impact Resilience Test Low Elongation Stress Test Metal Adhesion Test Peel Strength Test Permanent Extension Set Test General Test Conditions Normal State of Laboratory : The normal state of laboratory shall be as a rule at 20 +10 -0  ℃ and the test temperature shall be reported. Normal State of Test Specimens : Test specimens shall be, as a rule, allowed to stand at least 24 hr after vulcanization and 1 hr or more in the normal state before test. 1F-SG-00002 HYUNDAI KIA MOTOR ENGINEERING STANDARD (SPEC NO) MS 200-41 (SHT/SHTS) 3/58 Rounding of Test Result : The test results shall be rounded in accordance with KS A 0021 (Rules for Rounding Off of Numerical Values) and indicate