二零二三年 优质公开课Generalspecificationforcableplacement.pptxVIP

Design and budget of mobile communication engineeringGeneral specification forcable placementCourse team: Xiaoji Zhao Xuelian Fang Yueqiu Dong Liu Yang SHENZHEN POLYTECHNIC Contents 1Routing specification 2Binding specification 3Connection specification 4Layout of cable in cabinet 5Layout of cable between cabinet The routing of power lines, ground wires and signal cables meets the requirements of design documents ；Cables are distributed separately，the direction of the cables is clear and straight ，no crossing、firmly and moderately tied ；The cables are securely strapped to the cable rack，the spacing between the power cord and other unshielded cables is recommended to more than 100mm；Cable channel should be installed when wiring on the wall or floor，the wiring inside the standardized cabinet is run through the column and the slot in the cabinet 。1. Routing specificationSignal cablePower cable＞10cm The cables must be tied, and the bundled cables should be close to each other，and the appearance is straight and neat 。When the cable is bundled, the tie spacing should be 3-4 times the diameter of the cable bundle and the spacing is uniform。After binding, the excess parts should be trimmed and no sharp thorn be left at the joint；2. Binding specificationφ3~4 φStraight and neat??? When the cable is turning, large bending diameter should be used as far as possible, no binding can be made at the corner；The cables outside the cabinets should not be crossed as far as possible, especially no crossing away from the cabinet and 1m away from feeder window； The cable surface is clean, no construction marks, no damage and scratch on the sheath insulation layer;R2. Binding specification Do not hurt the cable core when making cable head； The head should be sleeved or wound with insulating tape, and the color should be consistent with the cable as far as possible；For the same type of cable , cable head length, sleev