二零二三年 优质公开课Equipmentslayoutrequirements.pptxVIP

Design and budget of mobile communication engineeringEquipments layout requirementsCourse team: Xiaoji Zhao Xuelian Fang Yueqiu Dong Liu Yang SHENZHEN POLYTECHNIC Contents 1Power equipment layout 2Wireless equipment layout 3Cable rack layout 4Other equipment layout Switch power as close as possible to wireless cabinet；Switch power as far as possible against the wall ；The AC distribution panel is close to the AC introduction point, and the cable length between the two shall be less than 10 meters ；The battery pack is placed on the beam or separately against the wall, channel steel can be considered to be installed in order to distribute pressure ；The battery is adjacent to the switch power , and the length of the DC line is as short as possible 。1. Power equipment layout The wireless device is facing the main walkway and is on the same straight line ；The wireless device is at an appropriate distance from the feeder window (usually ≤ 600mm)，and the feeder line length should be minimized ；The installation of the wireless cabinet can be 50 to 100mm away from the wall ,wall waterproof should be done。2. Wireless equipment layout The indoor cable rack is generally 400 mm wide ，installed above the equipment ，2300mm-2600mm from the ground， the cable rack is aligned with the front of the equipment。3. Cable rack layout400mm2300-2600mm Cable rack strengthen：celling suspension，side support，cable rack and wall reinforcement。And usually reinforced every 1.5 meters；The cable rack is above or below the feeder windowThe ground should be laid on the rack and connected to the indoor grounding。When the DC line from the battery pack to the switching power supply is placed vertically, the vertical rack should be installed。3. Cable rack layout The environmental monitoring box and the AC distribution box are installed near the door on the wall, and 1.4 meters away from the ground 。Wall mounting DDF or alarm box installed under