SAE AMS2774G-2020 镍及钴合金零件的热处理 Heat Treatment Nickel Alloy and Cobalt Alloy Parts.pdf

AEROSPACE AMS2774TM REV.G INTERNATIONAL., MATERIAL SPECIFICATION Issued 1 995-07 Reaffirmed 2001 -11 Revised 2020-12 Superseding AMS277 4F Heat Treatment Nickel Alloy and Cobalt Alloy Parts RATIONALE AMS2774G corrects an error in Table 3. 1 . SCOPE 1 .1 Pu「pose This specification specifies the engineering requirements for heat treatment, by pa时fabricators (users) or subcontractors, of parts made of wrought or additively manufactured nickel or cobalt alloys, of raw mate「ials during fabrication, and of fabricated assemblies in which wrought nickel or cobalt alloys are the primary structural components. 1.2 Application 1.2.1 Alloys Detailed heat treating instructions are specified for the age-ha时enable (precipitation-hardenable) and non-age-hardenable alloys listed in 8.2. However, this specification also may be used for alloys other than those listed in 8.2, provided that temperatures, soaking times, and cooling requirements are specified by the cognizant engineering organization. 1.2.2 Heat Treatments Heat treatments covered by this specification are as follows: Solution T「eating (see 8.4.7)