IEC-62660-动力电池标准.xlsVIP

Sheet3 Sheet2 Sheet1 IEC 62660-1：2010Secondary lithium-ion cells for the propulsion of electric road vehicles –Part 1: Performance testing 试验项目 章节号 标准要求 Test temperature? If not otherwise defined, before each test the cell shall be stabilized at the test temperature for a minimum of 12 h. This period can be reduced if thermal stabilization is reached. Thermal stabilization is considered to be reached if after one interval of 1 h, the change of cell temperature is lower than 1 K.Unless otherwise stated in this standard, cells shall be tested at room temperature using the method declared by the manufacturer. General charge conditions? 7.1? Unless otherwise stated in this standard, prior to electrical measurement test, the cell shall be charged as follows. Prior to charging, the cell shall be discharged at room temperature at a constant current described in Table 1 down to a end-of-discharge voltage specified by the manufacturer. Then, the cell shall be charged according to the charging method declared by the manufacturer at room temperature. Capacity? Capacity of cell shall be measured in accordance with the following steps. Step 1 – The cell shall be charged in accordance with 7.1. After recharge, the cell temperature shall be stabilized in accordance with 4.4. Step 2 – The cell shall be discharged at specified temperature at a constant current It (A) to the end-of-discharge voltage that is provided by the manufacturer. The discharge current and temperatures indicated in Table 1 shall be used. NOTE Selective test conditions are shown in Table A Annex A. The method of designation of test current It is defined in IEC 61434. ? Discharge current A Temperature°C BEV application HEV application 1/3It It Step 3 – Measure the discharge duration until the specified end-of discharge voltage is reached, and calculate the capacity of cell expressed in Ah up to three significant figures. SOC adjustment The test cells shall be charged as specified below. The SOC adjustment is t