APC NetworkAIR FM Precision Air Conditioner v.3.0 (Manual Addendum)说明书用户手册(1).pdf

Addendum—NetworkAIR® FM Precision Air Conditioner Overview The changes in this addendum apply to the chapter “Network Management Card” (pages 57–69) of the NetworkAIR FM—Operation, Maintenance, and Troubleshooting manual (990-1260A). APC Management Card Wizard (page 58) The APC Device IP Configuration Wizard replaces the Management Card Wizard. You can use the Device IP Configuration Wizard at a Windows® 2000, Windows 2003, or Windows XP computer to configure a Network Management Card. Windows NT® 4.0 is no longer supported. Menu changes for 3.0 (and later) firmware BOOTP DHCP configuration (page 58). Configure General Settings, which you access by selecting the Administration tab, the Network option on the top menu bar, and TCP/IP on the side menu bar, identifies how the TCP/IP settings will be defined. The possible settings are Manual, DHCP, BOOTP, and DHCP BOOTP (the default setting). Web interface (page 63). See “Security” in the Security Handbook for information on choosing and setting up your network security. On the Administration tab, select Network on the top menu bar and the access option under the Web heading on the side menu bar to enable or disable the HTTP or HTTPS protocols. Telnet/SSH (page 63). You can access the control console through Telnet or Secure SHell (SSH), depending on which is enabled. (An Administrator can enable these access methods by selecting the Administration tab, then Network on the top menu bar, and the access option under the Console heading on the side menu bar. SNMP (page 64). To disable SNMP, you must be an Administrator. On the Administration tab, select Network on the top menu bar and the access option under the SNMP heading on the side menu bar. FTP/SCP (page 65). To disable FTP, you must be an Administrator. On the Administration tab, select Network on the top menu bar and the FTP