挖一般土方施工工艺标准.docxVIP

挖一般土方施工工艺标准 Soil engineering n technology I。n n and measurement layout A detailed n plan should be prepared and submitted to the supervising engineer。After obtaining written approval for the n plan。the n work can begin. The embankment line and n should be remeasured every 30 meters。and the main control points of the route。such as n points and guide wire points。should be measured indirectly。During the n process。all control points should be protected and checked regularly。If any are found to have been knocked over or lost。they should be replaced immediately. Water level points and back-sight points should be set up in the safety zone outside the slope foot and within the red line。and then the horizontal n of the longitudinal and transverse ns should be measured。The measurement results should be recorded truthfully and in detail。After each n is measured。the measurement record book and the result data should be signed by the measurement engineer and the technical group leader and submitted to the supervising engineer for approval. II。n Seven days before the n work begins。a n plan including the following contents should be submitted to the supervising engineer for approval based on the n drawings and relevant ns in this chapter: 1.n n layout plan (including n traffic route layout); 2.n methods and res; 3.n of n equipment and labor; 4.Drainage or water level n measures; 5.n slope n measures; 6.Measures for soil n and waste disposal; 7.Quality and safety assurance measures; 8.n le。etc. During the n d。the approved n plan cannot be changed arbitrarily。If it needs to be modified due to special reasons。it can only be implemented after being approved by the supervising engineer。Seven days before the n work begins。the supervising engineer should be notified to review the field layout results of the n。After being approved by the supervising engineer。the n work can begin。During the n process。the geological recording work ns that facilitate the n n acceptance should be provided。an