家用交流稳压器的原理与维修电路图.docVIP

家用交流稳压器的原理与维修电路图 工作原理 大地牌,,,,型,,,交流稳压器的电气原理图见附图。整机可分主回路和控制电路两部分，,,和,,分别是输入与输出电压表。主回路是交流电源从输入端通往输出端的路径，包括空气开关,,、稳压与直通选择开关,,、调压变压器,、延时控制继电器,,和输入、输出接线端子等元器件。控制电路的功能有开机延时送电、稳定输出电压、过压保护及指示、欠压保护及指示等。 ,(取样电压与基准电压。 调压变压器,有两个二次绕组，其中一组,,经,,,桥式整流后，再经电阻,,和,,分压，取,,上的分压值作为交流稳压器输出电压高低的取样电压。,,,的绕组电压经,,,桥式整流，三端稳压器,,,,,,稳压，输出稳定的,,,,,电压向控制电路供电。发光管,,,,点亮标志着,,,,,电源工作正常。集成电路,,是四运放,,,,,,,，在这里作四电压比较器使用。,,,,,电压经电位器,,、电阻,,,,,分压，共取出四个分压值作为基准电压，分别送往四个电压比较器的相应输入端。电阻,,上的取样电压也同时送往电压比较器的输入端。取样电压和基准电压接入电压比较器输入端的规律是:检测交流稳压器输出电压是否高于额定值,,,,，其正输入端接取样电压，负输入端接基准电压，例如,,(,和,,(,;检测交流稳压器输出电压是否低于额定值,,,,，接法与上相反，例如,,(,和,,(,。认识这种规律对读懂许多品牌交流稳压器的电路原理图都有参考意义，但这种接入规律的前提是:检测结果为“是”时，电压比较器的输出端为高电平，这恰好是相关功能电路所需要的。 ,(电压偏高需要降压。 大地牌交流稳压器的输出稳压精度设定为?,,，当输出电压刚好等于,,,,时，调整电位器,,使电压比较器,,(,的反相输入端{6}脚所接的基the neighbouring frequency transmission planning, the system can accommodate more than more than 80 TV channels, 2 reverse channels. Taking into account the needs of e-commerce in the future, this system increase in backhaul bandwidth, take up to 4 channels. Wired TV distribution statistics following table: Wired TV information points distribution schedule-medical floor, rehabilitation floor, 1th, floor, 2nd, floor serial number a layer two layer three layer four layer five layer underground a layer underground two layer total medical floor 53 54 52 71 54 7 5 296 rehabilitation floor 7 5 5 4 4 2 27 2nd, floor 18 18 10 46 1th, floor-East floor 16 16 16 3 51 1th, floor-in the floor 21 15 12 5 53 1th, Floor-West floor 20 15 18 3 56 total 529 (3) information guide and the released system system used concentrated control, and unified management of way will sound video signal, and pictures and scroll subtitles, multimedia information through network transmission to the displayed Terminal, real-time to released visits information, and rehabilitation center image advertising, and medical common sense, and experts introduced, health life, information. and can at any time spots pictures, news, emergency notification, content, main distrib