ABB LVD-EOTKN132U-EN Using an ACS880 Standard Drive with 5 Speed Crane Pendant Preset Speed Controller 应用说明文档(英语).pdf

— Technical Note 132 Using an ACS880 Standard Drive with 5 Speed Crane Pendant Preset Speed Controller How to use Adaptive Programming to Create Additional Preset Speeds This document provides an overview of how to set up 5 preset speeds on a standard ACS880 using inputs from a 5- speed crane control pendant station. Because the preset speed array of the pendant is different than the standard binary truth table the drive accepts, custom preset speed selection and adaptive programming are required. This paper will review one way of parameter customization using standard Adaptive Programming. Adaptive programming or AP provides Boolean logic for customization by the user. It offers the ability to set parameter values, use timers, perform logical functions, and much more. There are certainly other ways one could customize to achieve the same results. Typical applications include Bridge and Trolley which typically are controlled by standard ACS880’s rather than the ACS880 crane version used on the Hoist. Digital Input Selection Truth Table is as follows: 1=On, 0=Off. Bits 0 and 1 will be set to a 1 in parameter 22.21 – Constant Speed Function, and 22.22 – Constant Speed Sel. 1, will be set to Selected.) DI3(22.23) DI4 (22.24) DI5(AP) DI6(AP) Speed Selection 0 0 0 0 Constant Speed 1 (22.26) (Speed 1) 1 0 0 0 Constant Speed 3 (22.27) (Speed 2) 1 1 0 0 Constant Speed 7 (22.32) (Speed 3) 1 1 1 0 Constant Speed 4 (AP) (Speed 4) 1 1 1 1 Constant Speed 5 (AP) (Speed 5) (For Reverse speed selection, DI2 will be on during all the reverse constant speeds and DI1