电子设计与单片机应用实训教程代码第十七章.docVIP

1：模拟智能温室（单片机）： #includereg52.h //主函数 #define uint unsigned int #define uchar unsigned char sbit light=P3^4; //光敏元件，亮度大于一定程度为0； sbit dht_scl=P3^5; //温湿度传感器 sbit dht_sda=P3^6; sbit rain=P3^3; //雨滴传感器 sbit stress=P3^2; //压力传感器 sbit pwm=P1^0; //pwm电动机 sbit motor1=P1^1; //电动机正向 sbit motor2=P1^2; //电动机反向 sbit led=P1^3; //灯 uchar tem,hum,ins; /*tem：温度，hum:湿度，ins:指令，ste: 舵机中断用计次fre外部中断命令*/ uint ste,fre; uint x,y,z; void delay(uint xms) //延时 { uint i,j; for(i=xms;i0;i--) for(j=110;j0;j--); } void delayum() //微秒级延时 {;;} void iic_start() //iic开始 { dht_sda=1; delayum(); dht_scl=1; delayum(); dht_sda=0; delayum(); } void iic_respons() //iic响应 { uchar i=0; dht_scl=1; delayum(); while((dht_sda==1)(i255)) { i++; dht_scl=0; delayum(); } } void iic_stop() //iic停止 { dht_sda=0; delayum(); dht_scl=1; delayum(); dht_sda=1; delayum(); } uchar iic_read() //iic读 { uchar i,date; dht_scl=0; delayum(); dht_sda=1; for(i=0;i8;i++) { dht_scl=1; delayum(); date=(date1)|dht_sda; } delayum(); return date; } void iic_write(uchar date) //iic写 { uchar i,com; com=date; for(i=0;i8;i++) { com=com1; dht_scl=0; delayum(); dht_sda=CY; delayum(); dht_scl=1; delayum(); } dht_scl=0; delayum(); dht_sda=1; delayum(); } void wenshi() //温湿度传感器读取程序 { iic_start(); iic_write(0x00); iic_respons(); hum=iic_read(); iic_start(); iic_write(0x02); iic_respons(); tem=iic_read(); iic_stop(); } void uart_send(uchar date) //将数据写入缓存区 { SBUF=date; while(!TI); TI=0; delay(5); } void iic_init() //iic初始化 { dht_scl=1; delayum(); dht_sda=1; delayum(); } void Tinit() //串口发送接收中断初始化 { TMOD=0x21; TH1=0xf3; TL1=0xf3; TH0=(65536-1000)/256; TL0=(65536-1000)%256; E