TC18钛合金机械支座模锻成形特性的研究.pdfVIP

HotWorkingTechnolog2022,Vol.51,No.9

TC18钛合金机械支座模锻成形特性的研究

秦芳I,李子亮2

(1.河北民族师范学院物理与电子工程学院，河北承德067000;2.河北科技大学材料科学与工程学院，河北

石家庄050091)

摘要：把TC18钛合金的应力-应变曲线数值导入Deform仿真软件中，建立了某型航天用钛合金支座模锻成形

仿真模型，研究了模锻速度和摩擦系数对钛合金支座模锻成形载荷、等效应变及最大变形速度等模锻成形特性的影响。

结果表明：随着模锻速度和摩擦系数增加，TC18钛合金支座模锻的最大成形载荷、最大变形速度都逐渐增加，而等效应

变先增加后减小；支座模锻成形最佳参数为模锻温度850°C,模具预热温度650°C,模锻速度10mm/s,摩擦系数0.3。

关键词:TC18钛合金；成形特性；机械支座；模锻

DOI:10.14158/j・cnki.1001-3814.

中图分类号:TG319文献标识码：A文章编号:1001-3814(2022)09-0110-04

ResearchonDieForgingCharacteristicsofTC18TitaniumAlloy

MechanicalSuort

QINFang1,LIZiliang2

(1.SchoolofPhysicsandElectronicEngineering,HebeiNormalUniversitforNationalities,Chengde067000,China;

2.SchoolofMaterialsScienceandEngineering,HebeiUniversitofScienceandTechnology,Shijiazhuang050091,China)

Abstract：Thestress-straincurvevaluesofTCI8titaniumallowereimportedintotheDeformsimulationsoftware,

andacertaintypeofaerospacetitaniumallosupportdieforgingsimulationmodelwasestablished.Theinfluencesof

forgingspeedandfrictioncoefficientontheforgingload,equivalentstrainandmaximumdeformationspeedoftitanium

allosupportwerestudied.Theresultsshowthatwiththeincreaseofdieforgingspeedandfrictioncoefficient,the

maximumformingloadandmaximumdeformationspeedofthesupportdieforgingaregraduallincreased,whilethe

equivalentstrainincreasesfirstandthendecreases;theoptimumdieforgingparametersofTCI8titaniumallosupportare

dieforgingtemperatureof850°C,diepreheatingtemperatureof650°C,dieforgingspeedoflOmm/sandfriction

coefficientof0.3.