塑胶电镀介绍.pptxVIP

塑膠電鍍介紹

PlatingonPlastics

塑膠電鍍介紹PlatingonPlastics

塑膠電鍍原理及注意事項PrinciplesofPlatingonPlastic

第一站素材選擇ABS塑料案例(Step1:SelectingMaterialABSPlasticCase)

1.最佳採用電鍍級ABS塑膠如圖所示其丁二烯含量15%~16%密著強度最佳SelectstheABSplasticsshowingontherightwhichthebutadieneis15%-16%.Itsadhesionisbest.

2.采用70%~95%PC+ABS材料要請供應商提供防火材料%、PC%、等相關資料Appliershouldofferfireproofmaterial,PC%,etc,andreferencesbeforeselecting70%-95%PC+ABS.

3.塑膠電鍍原料應完全乾燥(含水率0.1%下列)Materialsofplatingonplasticshouldbedriedtotally.

4.塑膠電鍍原料盡量防止染色Materialsofplatingonplasticmustpreventdyeing.

5